In a New York City apartment, the layout of a kitchen is usually decided as much by the building as by taste. Plumbing risers, gas lines, venting, structural walls and co-op or condo rules all set limits before a single cabinet is drawn. Choosing the right layout means understanding those limits first, then designing the best kitchen inside them.
This article looks at the three layouts we see most often in Manhattan and Brooklyn apartments, what each one asks of the building, and how to decide between them. For the wider planning process, see our kitchen renovation planning guide.
Start with what the building allows
Before comparing layouts, find out three things about your apartment:
- Where the risers are. Sinks and dishwashers need to drain into a stack. Moving them a few feet is often possible; moving them across the apartment usually is not.
- Whether the board allows wet-over-dry. Many co-ops will not let a kitchen sit above a neighbor's bedroom or living room, which can rule out relocating the kitchen entirely.
- How the kitchen can be ventilated. Some buildings allow a ducted hood to an exterior wall; many only allow recirculating hoods. That affects cooktop choice and where the range can go.
Your alteration agreement and the building's engineer will confirm these points. Our co-op renovation and condo renovation pages explain how those approvals work.
The galley kitchen
Galley kitchens, two parallel runs of cabinets or one run against a wall, are common in pre-war apartments and in many post-war buildings. They are efficient: everything is within a step or two, and the work triangle between sink, cooktop and refrigerator is short.
A high-end galley works when it is planned to the inch. Full-height cabinetry, panel-ready appliances and a consistent material from floor to ceiling make a narrow room feel deliberate rather than tight. The National Kitchen & Bath Association recommends a work aisle of at least 42 inches for one cook and 48 inches for two, which is a useful check before committing to deeper cabinets or a larger range.
The L-shaped kitchen
An L-shape uses two adjoining walls and leaves the rest of the room open. It suits square rooms and kitchens that open to a dining area. Corners are the challenge: blind corner cabinets waste space unless they are fitted with proper pull-out or swing-out hardware, and the corner is often where the sink or cooktop ends up.
In older buildings, the L-shape is also a good way to keep the sink near its existing riser while extending counter space along a second wall that has no plumbing.
The open kitchen
Opening the kitchen to the living room is the most requested change in NYC apartments, especially in pre-war layouts where the kitchen was built as a separate service room. It can transform how an apartment feels, but it needs the most checking:
- Walls. Some interior walls carry load or hide risers, flues or electrical feeds. An architect or engineer confirms what can come out.
- Ventilation. An open kitchen shares its air with the living room, so the hood matters more. Where ducting is not allowed, induction cooking and a high-capacity recirculating hood are a common answer.
- Design. Cabinetry becomes part of the living space. Islands, paneled appliances and integrated lighting need to read as furniture, not just storage.
Islands deserve careful measuring. An island that leaves less than the recommended aisle width on any side will feel cramped every day.
How to choose
Most owners decide by answering three questions: how many people cook at once, whether the kitchen should be seen from the living space, and how much the building allows to move. If the answers are one cook, a closed room and fixed risers, a beautifully detailed galley is often the best result. If you entertain and the building allows walls to change, an open plan with an island may be worth the extra approvals.
Building it well
Whichever layout you choose, the quality comes from the details: cabinetry scribed to uneven pre-war walls, stone templated after cabinets are installed, and appliances, lighting and outlets coordinated before walls close. We build kitchens with our own custom millwork and stone fabrication, working from your architect's or designer's drawings.
Gurri Remodel is a licensed NYC remodeling contractor that has been renovating apartments and homes since 1997. See our kitchen remodeling services, or contact us to talk about your kitchen.